How to Install a Pullout Kitchen Sink Faucet? Pull out Kitchen Faucet installation tips. Installing a kitchen faucet will give your kitchen a fresh update. Pullout kitchen sink faucets with their one-piece design are modern, stylish and convenient. Change your existing faucet and get a handle on the process.
Things You’ll Need:
- Adjustable wrench
- Plumber’s putty
- Flashlight (if needed)
- Pullout faucet
A stiff-necked kitchen faucet with a little swivel head clutters the back of your sink, what with the spigot, the hot and cold handles, and that squat black spray hose (which, let’s face it, always leaks). The current trend in faucets is a single, sleek arm protruding from the sink rim—hose, faucet, spray, and hot and cold controls all in one place. One hand, all functions.
Pull-out or pull-down kitchen faucets have a retractable spray hose hidden inside the traditional fixed spigot. Great for filling pots, cleaning dishes, and giving a head of lettuce a thorough rinse, they’re another brilliantly conceived and mighty cool-looking convenience in the world of kitchen expediency. Even better: Like most faucets, they’re a snap to install. Just the twist of a few fittings and you’ve brought your kitchen one step closer to the modern world.
Turn off water lines either at the main water supply, or at the sink if available. Have bucket and towel available in case of any leaks. Run plumber’s putty along the grooved side of the plastic putty plate and place it grooved side down over the sink holes.
Place the rubber washer and then the metal one over the middle sink hole. The deckplate will have long screws attached to it that will go into the left and right holes of the sink, while the faucet is installed in the middle one. Press the deckplate onto the plastic putty plate; it should be a tight fit.
Pull out the hose on the faucet until the hose is the same length as the supply lines. Insert the faucet into the middle hole in the deckplate.
Place the metal washer and lock nut onto the faucet shank from underneath the sink, over the hose and supply pipes. Do not over tighten. Use a flashlight if needed to see installation.
Install the wing nuts to the long deckplate screws by hand. Do not over tighten. If doing a single-hole installation, the deckplate is not required. Simply insert the faucet assemble into the sink hole. Place the deck washer and locknut onto the faucet shank and tighten.
Remove excess putty that got pushed out as a result of tightening the nuts. Gently separate the water supply lines to the left and the right. Connect water lines using an adjustable wrench. The hot water line will be handled in the same way. Supply lines are not included with the faucet, so you’ll have to use the existing ones or purchase new ones that are the same size as those that were removed.
Turn the water back on, and then turn on the faucet. Check for leaks. Run water for up to a minute to remove any air or debris that may have entered the lines.
Following these simple instructions, you will install kitchen faucet easily. If you wish to update your kitchen with a new pull out kitchen faucet, just send your inquiry by email now!